Takes a little patience to remove the door handle as well as remove the sensor part from the handle.
Audi door handle sensor not working.
Unbolt the door lock assembly from the door and then pull the assembly out.
Each door has a sensor in the handle.
Why is the outside door handle on a 2008 audi tt intermittently not working.
Are you having problems with your door locks either from the key fob or the inside handles.
Push down the clip to loosen the rod then pull the rod up and out of the door.
There is a plastic clip attached to this rod.
You should see a rod connecting the handle to the door lock assembly.
For the sensor your part number is probably 4g8927753b.
If the actuator was not replaced along with the handle this may be the cause.
This article will walk you through the potential causes of the problem and how to fix them.
I had to clear the door sensor odb code before it recognized that it was replaced.
They are notorious for going bad.
When one sensor fails the entire system shuts off.
If there is a kink in it it will prevent the latch from working.
If it is okay check the cable that runs from the handle to the actuator.
You just need to find which door handle sensor has gone bad and replace that sensor.